Need metal roof installation in Beloit? We come look first, tell you plainly what it needs, and put the price in writing before anything starts.
We have been setting metal panels on houses, churches, barns and additions for over twenty years, and the crews serving Beloit install them the same way we always have. Straight lines, correct fastener spacing, and closures at the ridge so wind driven rain has nowhere to go.
Not every Beloit roof needs the biggest job on the sheet. When we quote metal roof installation we tell you honestly whether a repair will hold, whether doing one section will do, or whether you are genuinely past that — and we would rather do the smaller job well.
Metal is our specialty, so if metal roof installation on your Beloit home opens the door to standing seam or a panel roof, we will price that right alongside the shingle option and let you compare the real numbers side by side.
Four steps and no surprises. This is how we have done it since 2002.
Panel type comes first — standing seam or exposed fastener — then color, then trim. We walk you through the trade offs on each one.
If the shingles are coming off, they come off, and every board underneath gets checked before anything new goes down.
We keep panels straight to a line rather than to the eye, because a metal roof shows every bit of drift the moment the sun hits it.
Every penetration gets a proper boot or flashing instead of a bead of sealant and a hope.
What comes up on just about every estimate for a job like this.
Around twenty standard colors. Green, burgundy, bronze, black, gray, tan and barn red are the ones most Beloit homeowners land on. We bring the chart with the estimate so you can hold it against your siding.
Most Beloit metal roof jobs land between about $12,000 and $30,000 in 2026, depending on square footage, pitch, panel type and how much tear off is involved. Standing seam runs higher than exposed fastener panels. We measure before we quote and the estimate is free.
Installed properly over sound decking, a metal roof should give a Beloit home 40 to 60 years. Standing seam often goes longer because there are no exposed fasteners to work loose or leak.
Sometimes. If the decking is sound and there is only one layer of shingles, a Beloit metal roof can go over the top on purlins. Two layers or rot underneath and we tear off first — and we say so before you sign.
Real feedback from homeowners we have worked for.
"Our church needed a new roof and the budget was tight. They worked with us on it, did beautiful work, and finished before the fall revival."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"Second roof they have done for our family. My sister used them first and would not hear of me calling anybody else."